Raspberry Pi Compute Module 3 + 8GB eMMC – CM3+/8GB
The Compute Module 3+ (CM3+) is a Raspberry Pi 3 Model B+ in a flexible form fator, intended for industrial applications.
The CM3+/8GB Compute Module contains the guts of a Raspberry Pi 3 Model B+ (the BCM2837 processor and 1GB RAM) as well as an 8GB eMMC Flash device (which is the equivalent of the SD card in the Pi).
- Broadcom BCM2837B0, Cortex-A53 (ARMv8) 64-bit SoC @ 1.2GHz
- 1GB LPDDR2 SDRAM
- 8GB eMMC Flash memory
This is all integrated onto a small (67.6mm × 31mm) board that fits into a standard DDR2 SODIMM connector. The Flash memory is connected directly to the processor on the board, but the remaining processor interfaces are available to the user via the connector pins. You get the full flexibility of the BCM2837 SoC (which means that many more GPIOs and interfaces are available than with a standard Raspberry Pi), and designing the Module into a custom system should be relatively straightforward because we’ve put all the tricky bits onto the Module itself.
- CM3 Schematics
- CMIO Schematics
To help you get started designing a PCB to use the Module, we provide an open-source breakout board, which is supplied with both a CM3+/32GB and a CM3+/Lite in an affordable development kit.
※若無法使用Paypal購買，請到 這裡 填寫表單購買，造成您的不便敬請見諒。